Part 3 - Assembling
You Will Need: 3x small jump rings, a fire brick, flux, steel tweezers, hard silver solder, a blowtorch, brass tweezers, fresh water, 2x pairs of flat-nose pliers, a pair of reverse-action tweezers, fresh water, pickle, a pickling unit, copper tweezers
To assemble the bracelet begin with three of the smaller jump rings. Take one, make sure it is fully closed and the ends are coming together and place it onto your fire brick. Paint it with flux and use your steel tweezers to place one small piece of hard silver solder across the join. Turn on your blowtorch and heat the jump ring all over until the solder flows, then use your brass tweezers to quench it in fresh water.
Link the second jump ring onto the first and close it so that the ends are touching using two pairs of flat-nosed pliers. Secure it into a pair of reverse-action tweezers so that the join is facing outwards and the first jump ring is protected behind the jaws of the tweezers.
Paint with flux and use your steel tweezers to place one piece of hard silver solder across the join. Turn on your blowtorch and heat just the exposed part of the jump ring until the solder runs.
Use your brass tweezers to quench it in cold water, then link the third jump ring through the second ring and secure it into the reverse-action tweezers in the same way as before.
Paint the join with flux and place one piece of hard silver solder across the join. Heat with your blowtorch until the solder runs, quench in fresh water, and pop it in the pickle.