Part 2 - The Elements
You Will Need: A fire brick, flux, hard silver solder, a blowtorch, steel tweezers, brass tweezers, fresh water, pickle, a pickling unit, copper tweezers
Take two of the tubes and place them end up on your fire brick so that they sit side by side. Paint with flux and use your steel tweezers to place one piece of hard silver solder on the top across the join where the tubes meet. Turn on your blowtorch and gently heat them until the solder flows down the join.
use your brass tweezers to quench it in fresh water and pop it in the pickle.
Repeat the same process once more with two more tubes.
These linking tubes will connect the three jump rings at the end of the bracelet and will be used to adjust the size of the bracelet.